![]() ![]() ![]() However, be prepared to increase your budget considerably since the beefed up structure will cost more and the downward pulling force of the guy wires will result in a more expensive guy and foundation anchor system. You can also specify that you would like single anchor points for many heights. If property constraints will not allow an 80% radius, you can order the tower to be designed with a shorter guying distance as low as 40%. Therefore, a 400’ tower might have the anchor placed at 320’ from the center of the guyed tower. Standard design is for the outer anchor to be at a distance between 70% to 80% of the height of the structure. The height and economies of design will dictate whether the structure has three or six anchor points at 120 degrees. However, the same model has various loading capabilities based upon the thickness and size of steel pipe or angle members used for vertical support and horizontal and diagonal bracing. Many tower manufacturers’ models end in two numbers that indicate the face width size in inches. The tower is supported by galvanized steel guy cables of varying sizes. The face width is the measurement of each side of the triangular structure that sits upon a tapered bottom section that is anchored to the foundation base by a pivot pin. The addition of heavier braced sections and torque arm guy points allow a tower to be engineered custom to its loading specifications. Guyed towers are utilized to achieve the maximum in elevation and loading at an economical cost. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |